Bently Nevada 330171-00-56-10-02-05 3300 5 mm Proximity Probe

Applications

The Bently Nevada 330171 5 mm Proximity Probe is designed for high-accuracy, non-contact shaft displacement and vibration monitoring in critical rotating machinery where early fault detection is essential for operational safety and reliability.

• Steam turbine rotor vibration monitoring
• Gas turbine shaft eccentricity and position tracking
• Centrifugal compressor axial displacement measurement
• Pump bearing wear and alignment diagnostics
• Industrial gearbox vibration condition analysis
• Power generation predictive maintenance systems
• Oil & gas rotating equipment health monitoring 

Advantages

This probe delivers stable and repeatable performance in demanding industrial environments requiring continuous condition monitoring.

• High-resolution 5 mm eddy current displacement sensing
• Stable output under high vibration and thermal variation
• Fully compatible with Bently Nevada 3300 monitoring systems
• Strong immunity to electromagnetic interference (EMI)
• Long-term signal stability with minimal drift
• Non-contact design reduces mechanical wear and failure risk
• Designed for 24/7 industrial monitoring applications

Technical FAQs (10 Questions)

Q1: What measurement principle does this probe use?
It uses eddy current technology for non-contact shaft displacement measurement.

Q2: Is it suitable for turbine applications?
Yes, it is widely used in steam and gas turbine monitoring systems.

Q3: Does it require physical contact with the shaft?
No, it operates without contact, ensuring higher reliability.

Q4: What system is it designed for?
It is designed for the Bently Nevada 3300 series monitoring platform.

Q5: What type of signal does it output?
It provides a linear analog signal proportional to displacement.

Q6: Can it operate in harsh environments?
Yes, it is engineered for high vibration, EMI, and temperature variations.

Q7: Is it suitable for continuous monitoring?
Yes, it supports 24/7 industrial monitoring applications.

Q8: What materials is it optimized for?
It is optimized for conductive metallic surfaces such as steel shafts.

Q9: Does it require frequent recalibration?
No, it maintains long-term stability with minimal recalibration needs.

Q10: What parameters does it measure?
It measures shaft vibration and radial displacement.